PURPOSE

The purpose of this document is to outline the instructions for how to install the Self-4000 EMV smart payment reader on a DRB XPT Kiosk.

EQUIPMENT NEEDED

• EMV Self-4000 Device (enclosed)
• Self-4000 power supply (enclosed)
• Mounting Bracket (enclosed)
• Screws: Type M3 16mm long (enclosed)
• Hex 2.5” Bit
• Torx bit – T10 
• USB Cable (enclosed)
• Socket – 5/16

PROCESS

1. Turn off the power to the XPT Kiosk.
2. Open the door, locate the gift card unit, and unplug any connectors going to gift card unit. 
   •        
3. Remove the gift card unit nuts (5/16) which will allow for the entire unit to be removed.
   •  
4. Under the card reader, wing nuts will be seen with the cover of the hole. Remove the wing nuts.
   • 
5. Once the wing nuts are removed and the cover is pulled off, you can remove the touchless pad and wire located between the front and back plate of the door.
   • 
6. With the plate removed, place the new bracket in its place and secure with wing nuts.
   •  
7. Place new reader in place and secure with 4 screws using a Hex 2.5 Bit.
   •  
8. Connect power cable to top left on EMV and plug it in. 
   •  
9. Connect USB cable and plug into carrier board.
   •  
10. Contact MisterIT (888-422-7343) for the remaining installation. 
11. They will need to update the RCM version of the software and make sure the reader works.
12. Remove the old kiosk decals and apply the new kiosk decal on the front of the unit.