PURPOSE

The purpose of this document is to outline the instructions for how to install the Self-4000 EMV smart payment reader on a Micrologic Gen 1 Pegasus Kiosk.

EQUIPMENT NEEDED

• EMV Self-4000 Device (enclosed)
• Self-4000 power supply (enclosed)
• Mounting/cutting template (enclosed)
• Torx T10 Bit
• Screws: Type M3 16mm long (enclosed)
• Hex 2.5” Bit 
• USB Cable (enclosed)
• 3/8 Nut Driver
• 2 – 18tooth saw zaw blades
• Hand File
• 2/6” Drill bit

PROCESS

1. Turn off the power to the Gen 1 Pegasus Kiosk.
2. Open the kiosk door and remove the plastic face coverings from the kiosk. Then remove the old credit card reader with a socket.
3. Remove the speaker with same socket.
   • 
4. Place template on the studs that held in the old card reader.
   • 
5. Using the Saw Zaw blade cut the inside of the template
6. File the edges with a metal file until it is smooth and the unit fits.
   •      
7. Place the bracket on the inside of the door and place the card reader outside of the door. 
   • Use the supplied screws to tighten the card reader to the bracket.
8. Dry fit the unit for fit and adjust as necessary. 
9. Clean up any debris.
10. Mount the unit.
    •      
11. Mount the speaker with contacts horizontally and connect the speaker wires.
12. Connect the power supply and USB cable to the new card reader.
13. Remove the old CC Swiper and install blank in its place.
14. Make sure to remove the swiper from the machine with the USB cable.
15. Contact MisterIT (888-422-7343) for the remaining installation. 
16. They will need to update the RCM version and make sure the reader works.
17. Remove the old kiosk decals and apply the new kiosk decal on the front of the unit.

HISTORY