How to replace a Pegasus Kiosk hard drive

PURPOSE

This document provides specifications for installation or replacement of a new Pegasus Kiosk SSD. This works for both Gen1 and Gen2 models.

PROCESS

Remove Old Hard Drive

Open the Pegasus Kiosk and locate the black PC mounted inside.
- TIP: Take a picture to document where all the cables are connected before you start.
Remove all cables and the 4 screws that mount the PC.
- NOTE: There are 2 screws on each side of the PC.
Remove the PC mounting bracket.
Remove the 6 screws from the PC housing and open the PC.
Open the PC and remove the SATA cable along with the 4 screws that hold the SSD housing in place.
Remove the SSD housing from the PC and remove the 4 screws that mount the SSD.

Install New Hard Drive

Mount the new SSD to the SSD housing plate.
Place the SSD housing back into the PC, tightening the 4 screws and reconnecting the SATA cable.
Place the PC cover back on and tighten the 6 screws.
Reinstall the PC mounting bracket.
Mount the PC back to the kiosk and reconnect all the cables, using the reference picture taken at the beginning.
Reach out to Mister IT to finish the kiosk setup.

HISTORY

Revised Date Revised By Revisions 7/14/2024 Carl Williams Created Document 7/22/2024 Yolanda Terrazas-Franco Updated formatting and grammar mistakes fixed 8/7/2024 Andrew poskey Moved to Fresh 3/14/2025 Andrew Poskey Updated title and content formatting