PURPOSE

You need to install a Meraki wireless access point (WAP)

PROCESS

Package Contents

Installation

1. Cat 6 cable run must be less than 300ft.
2. Mount WAP between 8 and 16 feet from the ground.
3. Mount WAP 18 inches away from all metal objects.
4. Install WAP and network wiring away from electric noise, such as:
   • Transformers
   • Microwave Ovens
   • Other Industrial Equipment
   • Motor Control Systems
   • 2.5 Ghz Cordless Phones
   • Heavy Duty Motors
   • Refrigerators
   • Fluorescent Lighting
5. If possible, install the WAP within 5 feet of a good electrical ground. This allows the WAP to be grounded to prevent damage from a lightning strike.
6. Unscrew the mount plate attachment screw.
7. Lift the mount plate release tab upwards.
8. While holding the mount plate release tab up, slide the mount plate off the Wireless Access Point in the direction shown below.
   • 
9. Using included wall anchors and screws, attach the mount plate to your mounting wall or ceiling.
   • 
10. Attach the antennas to the Wireless Access Point (all antennas are the same).
    • 
11. Attaching the Wireless Access Point to the mounting bracket.
    • 
12. Connect one end of grounding strap to grounding post with included screw and washer. 
13. Securely attach the other end nearby metal structure.
    • 
14. Connect the Ethernet cable to the Ethernet port (bottom of the Wireless Access Point).
    • 
15. You have successfully installed the Meraki WAP. 
16. If you have any questions, please contact Mister IT.