How to reset a Ruckus wireless access point
PURPOSE
You need to reset a Ruckus wireless access points (WAPs).
PROCESS
- Locate the reset pin hole on the rear panel.
- Insert a straightened paper clip in the hole
- Press the reset button until the power light will turn red.
- Keeping holding the button until It starts to blink green four times and the power light will turn off for a few seconds.
- Release the button.
- While the power light is off, the WAP is reset to factory settings.
-
WARNING: Holding the button for longer will stop this process and complete a normal restart instead.
- If done correctly, the light will turn red, then blink green, and then stay a solid green
- The WAP is now ready for Mister IT to configure.