How to Measure the Tunnel Device Locations

Guide for measuring the tunnel according to current standards.

Place a 100’+ tape measure into the grating so the zero-point lines up with the photo eye.
Run the tape measure down the full length of the tunnel
Write down the measurements of each device and/or relay in the tunnel.
- You can download a copy of the Relay Planner.xlsx locally to your computer to assist with saving measurements
To measure the wraps, grill brushes, and top brushes: take the measurement from the center mass of the hub with the air extended.
To measure the poodle brush and tire shine: take the measurement from the beginning of the brush with the air extended
To measure the chemicals and liquid application: take the measurement from the location of the closest nozzle to the entry eyes.
- Pay close attention to the platinum seal as the lights and chemical bars are often swapped.
To measure the blowers: take the measurement from the center of the arch
To measure the lights: take the measurement from the center of the LED's.

Revised Date Revised By Revisions 4/2/2025
Carl Williams Created Document 4/2/2025 Andrew Poskey Updated formatting for publishing