PURPOSE

Guide for measuring the tunnel according to current standards.

PROCESS

1. Place a 100’+ tape measure into the grating so the zero-point lines up with the photo eye. 
   
   • 
2. Run the tape measure down the full length of the tunnel
3. Write down the measurements of each device and/or relay in the tunnel.
   • You can download a copy of the Relay Planner.xlsx locally to your computer to assist with saving measurements
4. To measure the wraps, grill brushes, and top brushes: take the measurement from the center mass of the hub with the air extended.
   •           
5. To measure the poodle brush and tire shine: take the measurement from the beginning of the brush with the air extended
   •    
6. To measure the chemicals and liquid application: take the measurement from the location of the closest nozzle to the entry eyes. 
   • Pay close attention to the platinum seal as the lights and chemical bars are often swapped.
   • 
7. To measure the blowers: take the measurement from the center of the arch
8. To measure the lights: take the measurement from the center of the LED's.

HISTORY